GTO RB923 rev User Manual download pdf (Page 41)

Step D1:

Attach the closed position

stop plate vertically to the

inside bottom of the gate

that will receive the

second operator (for push-

to-open, install plate on

outside of gate). In this

illustration this is the gate

that will close first.

Installing The Second Unit

Step D2:

Install a closed position ground stop in driveway securely

into ground directly below the gate. The positive stop

plate installed in Step D1 should rest against the ground

stop in the closed position. For added security, install a

GTO Automatic Gate Lock (see Accessory Catalog).

The diagram below shows a dual gate, pull-to-open (gate opens into the property) installation on iron gates.

If you are installing a Push-to-Open (gate opens out) system see Push-to-Open Installation starting on page 31.

The open position stop for

the second gate is installed

the same as the first gate.

See instructions on page 16.

The Closed position stops

on a dual gate system

require a ground stop for

the second gate (first to

close) to be installed as

follows:

Receiver

Run up to 1000' of low

voltage wire to control

box from transformer.

(wire not included)

120 Volt Indoor

Transformer

(Surge Protector,

not supplied)

PVC conduit (not included) to protect wire from lawnmowers and weedeaters.

Control Box with Battery

Power Cable

Closed Position Positive Stop Plate

Gate Bracket

Post Bracket Assembly

GTO/PRO 2000 – First Operator

GTO/PRO 2200 – Second Operator

Closed Position

Stop Plates

Closed Position Stop Plate mounted

on second gate (first gate to close).

Open Position Stop

Wood, metal, or concrete

post set in concrete.

Gate Hinge

Open Position Stop

Not to exceed 110° Not to exceed 110°

Closed position stop plate

Low profile ground stop

in middle of driveway

FRONT VIEW

SIDE VIEW

Ground Stop (under gate)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

GTO RB923 rev User Manual Page 41

Comments to this Manuals