GTO GP-SW050 User Manual download pdf (Page 18)

Bolts

and

Washers

Reducer

Arm

Key

Closed Gate

Closing

Gate Bracket

Operator Arm

Reducer Arm

(approx)

5°-10° Angle

Clevis Pin

Hairpin Clip

Output Shaft

Fig. 1

Fig. 2

Fig. 5

Fig. 6

Fig. 4

CAUTION:

DO NOT STAND

IN THIS AREA

Fig. 3

1 2 3 4

OPTIONS

MODE 1

MODE 2

OPEN DIR.

SLV OPN

DUAL MODE

LOW BATT

>>>

SIMUL

SLAVE

SECURE

OFF

<<<

DELAY

MASTER

SAFE

Connecting the Gate Arm to the Gate

NOTE: Gate Arm’s length can be adjusted

by rotating the gate arm’s tube before

mounting it to the gate bracket.

(Fig. 5)

1. Install the key into the output shaft. (Fig. 1)

2. Fit the end of the reducer arm onto the output shaftasshownand

tighten the bolts. (Fig. 2)

3. Turn the power on.

4. Set DIP switch 1 to designate the operator arm as left or right (Fig. 3)

 (rightisshownhere).

5. Manuallymove gate to the closed position. (Fig. 4)

6. Unfold the arm to approximately a 5-10° angle. (Fig. 4)

7. Use ‘CLOSE’ button on control board to move operator arm/reducer arm to the gate. CAUTION: Be careful

not to stand in the gray area surrounding the operator. (Fig. 4) Be prepared to stop (using the ‘STOP’ button)

whenthegatearmandreducerarmnearthedesiredposition.

NOTE: Use ‘JOG’ buttons to ne tune the position.

8. Mark the position of the gate bracket holes on the gate, drill holes and mount bracket.

9. Fit the end of the operator arm into the gate bracket and attach using clevis pin and hairpin clip. (Fig. 5)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

Comments to this Manuals

No comments

GTO GP-SW050 User Manual Page 18

Comments to this Manuals

Related products and manuals for Gate Opener GTO GP-SW050